PDA

View Full Version : WTB: Syd 5x114.3, 6 or 8mm Hub centric spacer set



The_Giefster
27-08-09, 11:28 AM
As the title says.

I am after a set of 6 or 8mm Hub centric spacers in 5x114.3

The_Giefster
28-08-09, 12:55 PM
Can anyone source Ichiba products?

As this looks good for me. http://www.ichibausa.com/10alwhsp9.html

Description:

Wheel Spacers are made from Aluminum/Magnesium alloy. They are incredibly strong and very lightweight. These are hubcentric spacers that is specifically made to each vehicle; will fitted on your vehicle's original hub perfectly without any gap. Wheel spacers move the wheel out from the hub, effectively widening the stance of the vehicle and lowering its roll center. This simple modification increases lateral stability, which in turn provides improved handling & greater safety.

Spec:

Bolt Pattern: 5/114.3
Center Bore: 67.1
Thread: 12x1.5
Longer Studs Included

Sold as one pair (2pcs) with 10pcs longer studs.

Note:

The holding clamp / bolt in the brake disc / drum must be removed if our spacer shows no relief. The spacer must always fit flush with the hub.

snappy
28-08-09, 02:21 PM
I didn't know hub centric spacers come in 6 or 8 mm's.

5hu7o
28-08-09, 02:36 PM
neither did i?

Mr Happ
28-08-09, 02:53 PM
10MM hubcentrics can be machined down to 8mm or 6mm

wheelworx in SA will do them custom and post them to you

5hu7o
28-08-09, 02:59 PM
i was thinkin that too but it doesnt seem safe. then again spacers altogether arent safe

Mr Happ
28-08-09, 03:04 PM
well they are a less than ideal solution

The_Giefster
28-08-09, 03:57 PM
Thanks Mr Happ, i'll give them a call.