Forum: Workshop

Anyone know a site I can get parts for my bluebird project? Also is anyone selling a ca18det motor and gearbox?

OK Guys! Havent posted here in a while.... so I dunno if peeps around here are still interested in this kinda thing... but here goes! So... I...

After a mate put me onto watching Rustoleum paint jobs on youtube we decided to give it a go and paint his r32. Now we couldn't find Rustoleum...

Hi All, I have bought a set of rims for my s15 and need some help with tyre sizes, im not into the stretched look so would like a set of tyres...

Anyone know where I can source one of these or an alternative? I've asked Bosch Aus and they're clueless. The code etched on the outside of the...

Hello fellow Honda Enthusiasts, I write to you today a write up & review on an aftermarket computer now available for the Honda K series. The...

hey guys. just wondering if its possible to fit the factory cruise control system from an auto r34, i presume, into my manual r34? i'd buy the auto...

hello question, setting height and the thread with the red on top just popped out when i set the spring and just using the height adjustment ...

I was wondering if anyone had any experience with any fuel savers. I tried one of those magnets and I have to admit, it instantly quieted down the...

Hey Guys So just a quick questions about wheel bearings - are skyline s13/14/15 bearings the same? My car runs R32 GTST brakes, and the rear...

Hey guys, As my car was sitting for such a long time,the fuel going bad + moisture ended up coating the inside of my tank with rust. I'm just...

Hey guys, Just have noob question and hope you guys can help. I recently purchased a set of Work 11r and McGard STi Lug spline drive nuts...

I'm looking to go a full exhaustsystems including extractors but. Not sure what brand to get I would like to get a apexi system but can't find one...

Hey Wondering if anyone has a good recommendation for a place to do bits and pieces in the engine head that needs to be replaced? I just need new...

Hi Guys So my daily, a 2001 Nissan Pulsar ST 1.8L has just as of this week started having a transmission issue. Its an automatic gearbox, and...

Hey guys looking at some R33 GTR seats for my 180sx - however have heard mixed reports about the height actually being slightly higher than the...

Can anybody help me and tell me if this would work or not? Will modifications need to be done to get the rail to fit? They're both side feed so i'm...

Finally had the time to start on something thats been on my mind for quite a long time. Being a big apple iphone/ipad user, i knew i had to get this...

I have a n14 series2 jap spec and wanna get a short shift kit and a lighten flywheel and a set of tuned stainless steel extractors but not sure what...

So, my mother has a KA9 Honda Legend with a dealer-optioned electric corner pole that she relies on for manoeuvring in tight spots, which...

How would you know that they're worn out, or need replacing?

Will be needing lug nuts for my ENKEI RPF1 Rims Wondering which one out of these two or you can suggestion would be best for the rims / car. ...

Hey guys just got a set of new rims and my wheel nuts that i have on atm are wearing away slowly so im in the market for a some extended wheel nuts....

I own a '97 WRX. sometimes it will hesitate or even stall out. I'm 98% certain that I need a new fuel pump. Am I correct in my diagnosis?

Hey guys I'm thinking of getting a vertex carbon boot lip for my pewter s15 just wondering if anyone has a black or carbon boot lip to see if it...