Forum: Workshop

Can anyone recommend a good adhesive glue that cures slowly (roughly 24 hrs) and is ideal for spoilers contacting glass only , not paint. ...

Hi guys, Are EVO 8 MR recaros the same mounting point wise as other recaros? If I wanted to get one to mount them to say an S15 which Bride...

Hey guys, Checked out a 1990 NA6 and saw abit of a wobble on the crank pulley. Is this amount of wobble ok or is it on it's way out? ...

Anyone know a site I can get parts for my bluebird project? Also is anyone selling a ca18det motor and gearbox?

Finally had the time to start on something thats been on my mind for quite a long time. Being a big apple iphone/ipad user, i knew i had to get this...

Anyone know where I can source one of these or an alternative? I've asked Bosch Aus and they're clueless. The code etched on the outside of the...

Hello fellow Honda Enthusiasts, I write to you today a write up & review on an aftermarket computer now available for the Honda K series. The...

hey guys. just wondering if its possible to fit the factory cruise control system from an auto r34, i presume, into my manual r34? i'd buy the auto...

hello question, setting height and the thread with the red on top just popped out when i set the spring and just using the height adjustment ...

Hey Guys So just a quick questions about wheel bearings - are skyline s13/14/15 bearings the same? My car runs R32 GTST brakes, and the rear...

Hey guys, As my car was sitting for such a long time,the fuel going bad + moisture ended up coating the inside of my tank with rust. I'm just...

Hey guys, Just have noob question and hope you guys can help. I recently purchased a set of Work 11r and McGard STi Lug spline drive nuts...

I'm looking to go a full exhaustsystems including extractors but. Not sure what brand to get I would like to get a apexi system but can't find one...

Hi Guys So my daily, a 2001 Nissan Pulsar ST 1.8L has just as of this week started having a transmission issue. Its an automatic gearbox, and...

Hey guys looking at some R33 GTR seats for my 180sx - however have heard mixed reports about the height actually being slightly higher than the...

Can anybody help me and tell me if this would work or not? Will modifications need to be done to get the rail to fit? They're both side feed so i'm...

I have a n14 series2 jap spec and wanna get a short shift kit and a lighten flywheel and a set of tuned stainless steel extractors but not sure what...

So, my mother has a KA9 Honda Legend with a dealer-optioned electric corner pole that she relies on for manoeuvring in tight spots, which...

How would you know that they're worn out, or need replacing?

Will be needing lug nuts for my ENKEI RPF1 Rims Wondering which one out of these two or you can suggestion would be best for the rims / car. ...

Hey guys just got a set of new rims and my wheel nuts that i have on atm are wearing away slowly so im in the market for a some extended wheel nuts....

I own a '97 WRX. sometimes it will hesitate or even stall out. I'm 98% certain that I need a new fuel pump. Am I correct in my diagnosis?

Hey guys I'm thinking of getting a vertex carbon boot lip for my pewter s15 just wondering if anyone has a black or carbon boot lip to see if it...

Hello, I am wondering what would need to be modified to turbocharge a nonturbo car. I am pretty handy and it doesn't look that complicated actually....