3D Modelling & Printing - http://omgpham.com/3d-modelling-printing
Lately I've been spending more time learning how to model parts in 3D, still new so bare with me. It's not a new concept to me, but I am using Fusion 360 mainly now and sometimes a bit of SolidWorks.
I've done some prints in the past, a good example would be the bulk head connector plate I drew up and printed. Had it installed in the car while I waited for the final piece to be laser cut from steel.
And now I'm starting to move onto slightly more detailed designs. Starting of with "remixing" a design from Thingiverse.
4AGE Black Top Velocity Stack - http://www.thingiverse.com/thing:25207
And my "remixed" version, which is basically modified for Silver Top engines instead of Black Top and increasing overall length to 115mm.
4AGE Silver Top Velocity Stack - http://www.thingiverse.com/thing:2016083
I than scrapped that design altogether and did one from scratch, increased the radius lip profile and removed the side bracing. The print below was done in ABS and I'll be testing it for clearance and heat resistance. If all goes well, I'll most likely print my final design in ABS. If not, other materials like Nylon and Poly-carbonate are alternative options for heat resistance.
And this is another*design I quickly modelled. Main differences being the bottom flange, length adjusted to 105mm and the dimpled internal surface. NO idea how that'll work for airflow, good or bad, but it's fun drawing these and 3D printing them! The idea is from dimpled surfaces on golf balls, and I've seen shops machine dimples onto the back of inlet valves and cylinder head ports.
And this is how the print came out.... About halfway up the velocity stack, the wall was a tiny bit too thin and the dimples were too deep! Not something I was expecting, but I'll learn from this one and make revisions. This print was also done at 300 micron layer height, I think it needs to be 100-200 micro next time.
And finally, this is an airbox/plenum that will mount to my current Pipercross filter plate. Still needs some work here and there, but I'm pretty set on the general shape of it and the inlet is 4.5" diameter. The final product could be moulded from the 3D print and made with carbon fibre, or possible printed entirely out of fibre infused nylon for strength and heat resistance.
More to come!